Scotsman CU0415 - Manual (Page 25)

Service Manual for Models CU0415, CU0715 and CU0920
August 2013
Page 24
Removal and Replacement
Curtain
1. Remove front panel and switch unit Off.
2. Remove top panel.
3. Remove evaporator cover.
4. Locate white curtain top at front of evaporator, pull
up on it and remove from the unit.
5. Slide new curtain down in same place as original,
into the slot between the plastic evaporator frame
and the front of the reservoir. Push curtain down
into the slot as far as it will go.
6. Check that curtain hangs freely and reassemble
the parts removed.
Cube Deflector
1. Remove front panel.
2. Shut unit off.
3. Open door, lift original cube deflector up, twist
slightly and pull forward, out of the reservoir.
4. Install new deflector in reservoir, be sure deflector
is snapped down at the front, it fits tightly on the
reservoir edge.
5. Switch unit on and observe spray pattern, be sure
deflector is not interfering with water spray.
Cube Deflector Must Snap
Onto Reservoir Wall Edge
Curtain Top Edge
Curtain
Top Edge