Scotsman Flaked Ice Machines - Manual (Page 7)

Auger Removal - AFE325
1. Disconnect electrical power.
2. Shut off water supply and drain reservoir and
evaporator.
3. Pull up on black rubber cap and remove it.
4. Remove two allen head screws holding spout
assembly to evaporator and disconnect spout from
evaporator.
5. Remove one screw holding top bearing retainer to
evaporator. It is holding the spout mounting plate to
the evaporator.
6. Pull up on cap hook to remove auger. If more
force is required, use a 12 inch length of 1/8" chain,
with each end cut into a hook. Remove the cap hook
and insert the chain into the holes. Insert a wrench
or hammer through the chain and pull up to pull out
the auger.
Another method is to use a slide hammer puller. To
use, use a snap ring pliers to remove the cap hook
and the cap.
Remove the bolt at the top of the auger.
Thread the slide hammer into the auger, and use the
slide to remove the auger.
Page 6
Using Slide Hammer
Top View, Spout Removal
Spout Removal
Allen
Head
Screw
Retaining
Screw
Cap Hook
Spout
Using Chain