Scotsman Flaked Ice Machines - Manual (Page 11)

Auger Removal - MFE400
1. Disconnect electrical power.
2. Shut off water supply and drain reservoir
and evaporator.
3. Remove necessary panels to get access
to the side of the evaporator opposite the
spout.
4. Remove styrofoam cap.
5. Remove two screws from the side of the
evaporator.
6. Pull up on cap hook to remove auger.
If more force is required, use a 12 inch
length of 1/8" chain, with each end cut into
a hook. Remove the cap hook and insert
the chain into the holes. Insert a wrench or
hammer through the chain and pull up to
pull out the auger.
Another method is to
use a slide hammer
puller. To use, use a
snap ring pliers to
remove the cap hook
and the cap.
Remove the bolt at the
top of the auger.
Thread the slide
hammer into the auger,
and use the slide to
remove the auger.
Page 10
Back View of MFE400
Remove Two Screws Pull Auger Up and Out
Foam Cap