RGBLink VSP 9516S Quick Start - Manual (Page 9)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
8
How to Do Customized Output Resolution
Push the [MENU/EFFECT] button to enter the menu items, turn the knob and choose , push
the knob to confirm. Turn the knob, choose , push the knob to confirm and go into
the output format menus, as following:
STANDARD--Standard resolution.
CUSTOM--Used defined resolution setting.
Push knob and go into menu:
1. Turn the knob on each digital position, and change the value of the digital by the digital buttons on the
front panel.
2. After the digital, push the knob will add *, means before * is the horizontal size. Same operation for
vertical size:
3. After the digital, push the knob will add @, means before the @ is the vertical size, and after the @ is
the refresh rate. Only digital 50 or digital 60 supports for the refresh rate. Use the digital buttons to
finish the settings.
4. After input all the values, push knob to enable VSP 9516S to output this resolution. VSP 9516S will
take 5-10 seconds to enable this output resolution.
How to Set up the Size and Position of the Single Image
Push the [SCALE/CROP] button, and enter the scale function menus, the OLED module show as
follows.
The lights of number button 0~9 turn on, user can adjust the following items by knob or number buttons.
H SIZE: Width setting.
V SIZE: Height setting.
H POS: Horizontal phase setting.
V POS: Vertical phase setting.
RESET: If image quality distorts by improper operation, it can be recover by reset.