How to set up the volume, How to realize led display connection – RGBLink VSP 9516S Quick Start User Manual
Page 12
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
11
In single image mode, the operations are as follows:
1. Push [MENU/EFFECT] to enter the menu items, turn the knob, choose
confirm, turn the knob, and choose
2. Turn the knob, and choose
“OFF”, disable the mute function.
3. Turn the knob, choose
In PIP mode, first, choose IMAGE A or IMAGE B as audio input source, specific steps are as follows:
MENU AUDIO AUDIO IN IMAGE A/IMAGE B, or push the [IMAGE1/IMAGE2] button,
choose IMAGE A or IMAGE B, then repeat the step1 to 3 above.
How to Realize LED Display Connection
VSP 9516S can realize three connections as follows: connecting the Port D or Port U of one sending
card to LED display, connecting the both Port D and Port U of one sending card to LED display,
connecting the Port D and Port U of two sending cards to LED display. The following are the detailed
operation steps of the three connections.
1. Connect the Port D or Port U of One Sending Card to LED Display
Here we take No.1 sending card, port U1 for example. (Note: No.1 sending card
corresponding to port D1 and port U1, No.2 sending card corresponding to port D2 and
port U2.
(1) First, make sure that the device is in normal operation. The red power indicator lights
when the device has power supply and the green signal indicator lights when device
has signal input.
(2) Choose the input signal, for example, choose DVI.
(3) Connect the cable to Port U1.
(4) Turn the knob, choose