Research Concepts RC4000 - Manual (Page 75)

RC4000 Antenna Controller Chapter 3 Software
67
3.2.2.8 Settings
The SETTINGS mode provides a way to change the operational characteristics of the RC4000 without
requiring to go to the configuration group of screens. It also provides a way to reset a drive error without
going to the DRIVE RESET maintenance screen.
1-LOCATE SOURCE: RF SETTINGS
<0>RESET DRIVE
<1>CHANGE SETTING MENU
<0>RESET DRIVE
This selection is only available if an azimuth, elevation or polarization drive error (jam or runaway) is
active. Selecting 0 will attempt to clear the error.
1-LOCATE SOURCE:
SOURCE <0-NONE 1-RF 2-BCN 3-RCV2 4-DVB>
Selection 2 allows the user to change the signal source that will be used with the LOCATE function.