Research Concepts RC4000 - Manual (Page 18)

RC4000 Antenna Controller Chapter 2 Hardware
10
2.1.2 Boardset Interfaces
The interfaces available from each RC4000 board are detailed in this section. For context, the most
typical use of individual interfaces within an antenna system is described. Differences to these interfaces
and how they are accommodated for a particular mount will be described in Mount Specific and
Enclosure Specific appendices.
Multiple connector types are used by the boardset. The following table assigns each connector type a
number and shows which connectors on each board use that type. Section 2.1.2.4.x (x = type) will
provide details of each connector type.
Type Description Drive Board Computing Board Options Board
1 Phoenix Terminal Header J1
2 Molex Friction Lock Header J2 J5, J8 J1, J2, J3, J4,
J10, J12, J13, J15
3 Right Angle Shrouded Header J3 J1, J7 J6
4 Right Angle JTAG J4
5 Drive Terminal Block J5
6 Phoenix Header J2, J3, J4
7 USB J6
8 Tyco Vertical Header J9, J11, J12 J11
9 Unshrouded Header J10
10 Phoenix Double Header J13 A&B, J14
A&B
11 SMB J8 (+RF J1-4)
12 Ethernet J9
As each interface is defined its connector designation, PCB board nomenclature, pin count and connector
type will initially be shown in bold. For example:
J1 "AC Power" 3 pin Type 1
If there is no nomenclature on the PCB for a particular connector, it will be shown as "none ".