Research Concepts RC4000 User Manual
Page 16
RC4000 Antenna Controller
Chapter 2
Hardware
8
When an AC power supply is present, a .375" thick block of material must be placed between the power
supply and the bottom plate to conduct heat to the enclosure.
-- block needed if DC ????
The following drawing shows the mounting hole spacing for the RC4000 boards. The Power/Drive board
and the Computing/Interface board utilize all nine mounting holes. The Options board (on top in previous
picture) is narrower and only uses the six inner mounting holes.
The previous picture shows the complete stack attached to a mounting plate (M-4KPLT1) built by RCI.
The following diagram shows the dimensions of this plate. This diagram is included to provide guidance
for attaching a boardset to an enclosure.
NOTE: the RC4000 boardset may be purchased attached to the M-4KPLT1 plate.