Remotec ZXT-310 V1.2 - Manual (Page 7)

7
Change Z‐Wave‐to‐IR Channel (EP) on ZXT‐310
Step Setup Key
LED Indication Status on
ZXT‐310
1
Press and hold PROG button on
the ZXT‐310 for 3seconds to start
switching the EP
(1‐>2‐>3‐>4‐>5‐>6‐>1‐>2…)
• LED flashes once = EP1
• LED flashes twice = EP2
• LED flashes 3 times = EP3
• LED flashes 4 times = EP4
• LED flashes 5 times = EP5
•
LED flashes 6 times = EP6
Include / Exclude device to network
Adding Device to the Network
Step Setup Key
LED Indication
Status on
ZXT‐310
1
Make sure ZXT‐310 switched to
Channel 1 (EP1) • LED flashes
once then
keep on
2
Refer to your primary controller
instructions to process the inclusion
setup procedure. ‐
3
Press the PROG button on
ZXT‐310 • LED flashes
twice then
keep on
• Device
inclusion
completed
Note 1: Red LED flashes 6 times means the setup process is failed.
Please redo the process again.
Note 2: If you can’t add the ZXT-310 to network, it might have been
included in another Z-Wave network or the ZXT-310 is not on Channel
1 (EP1). In this case, please delete it following the steps in the
[Deleting Device from the Network] section then make sure ZXT-310 is
on the Channel 1 (EP1) and add it again.
Note 3: This step can be skipped if the device is already existed in the
network.