Remotec ZXT-310 V1.2 - Manual (Page 16)

16
successful
Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
End‐Point Selection Control
Set target end point by configuration command class
Step Setup Key
LED Indication
Status on
ZXT‐310
1
Make sure ZXT‐310 switched to
Channel 1 (EP1) • LED flashes
once then
keep on
2
Refer to your primary controller
instructions to process the
configuration setup procedure.
‐ Parameter: 38 (0x26)
‐ Value: 1 (0x01) = EP1
2 (0x02) = EP2
3 (0x03) = EP3
4 (0x04) = EP4
5 (0x05) = EP5
6 (0x06) = EP6
(Enter the Endpoint number 1 ‐ 6
which you want to configure)
‐
3
Press the PROG button on
ZXT‐310 • LED flashes
twice then
keep on
• End point
selection
successful
Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.