Ir port mapping – Remotec ZXT-310 V1.2 User Manual
Page 11

11
IR Port Mapping
Mapping individual Channel to individual Port in ZXT‐310
L Important
− Please make sure that the “End point selection control” has
completed (if necessary) before process the following setup.
Step
Setup Key
LED Indication
Status on
ZXT‐310
1
Make sure ZXT‐310 switched to
Channel 1 (EP1)
• LED flashes
once then
keep on
2
Refer to your primary controller
instructions to process the
configuration setup procedure.
‐ Parameter: 29
‐ Value: 01
(Enter the IR port number 1 ‐6 which
you want to transmit the IR signal)
‐
3
Press the PROG button on
ZXT‐310
• LED flashes
twice then
keep on
• Set IR Port
output
successful
Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
Note 2: All the Simple AV Channel / Z-Wave-to-IR Channel will map to
“IR Port 1” by default if user has not go through the above setup
procedure or Z-Wave remote controller does not support “Multi-
channel Command Class”.