beautypg.com

Ir code selection – Remotec ZXT-310 V1.2 User Manual

Page 10

background image

10

IR Code Selection  

Selecting an IR Device Code in ZXT‐310 
 

L Important 

− Please  make  sure  that  the  “End  point  selection  control”  has 

completed (if necessary) before process the following setup. 

 

Step 

Setup Key 

LED Indication 

Status on         

ZXT‐310 

Make sure ZXT‐310 switched to 
Channel 1 (EP1) 

• LED flashes 

once then 
keep on 

Refer to your primary controller 
instructions to process the 
configuration setup procedure.  

  ‐ Parameter: 27 

  ‐ Value: 0001 (Refer to IR code list of 
ZXT‐310) 

‐ 

Press the PROG button on  
ZXT‐310 

• LED flashes 

twice then 
keep on 

• Entering 

device code 
successful 

Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.