Remotec ZXT-310 V1.2 User Manual
Page 3

3
ZXT-310
(Z-Wave-to-AV IR Extender)
Operating Instructions
Introduction
ZXT‐310 is a Z‐Wave‐to‐AV IR Extender (Figure 1) and it works with
any Z‐Wave compliant controller or gateway by translating Z‐Wave
Simple AV command to IR control code. User can set the IR code from
the built‐in code library of ZXT‐310, or use the learning function of
ZXT‐310 through any Z‐Wave controller or gateway.
Figure 1. Operation diagram
It also supports Z‐Wave networks with multiple gateways and
controllers. Like every Z‐Wave accessory, the user will need to include
the ZXT‐310 into his Z‐Wave network using the primary controller.
Then, the user can use either the primary controller or secondary
controller to configure and setup the ZXT‐310 using Z‐Wave’s
configuration command class. Once the configuration and setup is
completed, the controller can use Z‐Wave’s “Simple AV commands
class” to control their IR‐controlled AV equipment with the ZXT‐310.
User can enjoy fully wireless control and home automation system
anywhere at home.