REMKO PWW Series - Manual (Page 17)

17
Control unit MSRD 2.5
0 D
U
1
2
3
4
7
8
9
10
11
12
13
14
15
16 17
18 5
6
S1
R1
K1
13
14
K1
F1
6,3 A
H1
X1
X2
K1
A1
A2
PE L1 L2 L3 N PE U1 V1 W1 U2 V2 W2 TK TK
15
RT RT
16
4
4
4
11
1
3
5
13
2
4
6
14
Raumthermostat Thermokontakte
im Motor
Einspeisung 400 V / 50 Hz
Erdung nach örtlichen Vorschriften
Motor 3~
Thermoschutz
für 2 Geräte
Thermoschutz
für 3 Geräte
Thermoschutz
für 4 Geräte
weitere Thermokontakte
in Reihe schalten
13
TK
14
TK
13
TK
14
TK
13
TK
14
TK
6 7 8 9 10 11 12 14 13 1 2 3 4 5
1 3 5
2 4 6
Circuit and wiring diagram
We reserve the right to make changes to dimensions and design in the interest of technical advances.
motors must not exceed the per-
missible switching capacity of the
control unit.
The thermal contacts of all motors
must be connected in series.
Note on safe operation
Earthing, multiple earthing or
protection switching and mains
protection must be carried
out on-site according to VDE
specifications and the regulations
of the responsible electricity supply
company. Only specialists may
establish electrical connections
based on the wiring diagrams in
compliance with the applicable
regulations, taking into account
local regulations.
three-phase 400V,
two-speed fan
maximum switching capacity 2.5
kW
, surface mounting, motor
protection by means of built-in
thermal contacts in fan motor.
Design
Sturdy plastic housing,
Degree of protection IP 41.
Totally-insulated according to VDE.
Front plate with symbols for switch
positions, supply and protective
conductor terminals, main con-
tactor, control switch with the
functions “Off/Setting 1/Setting
2”, control fuse, indicator light
(extinguishes on fan faults and/or
interruption of power supply
to
control unit), fault reset button,
terminals for motor output, termi-
nals for thermal contacts and room
thermostat.
Reconnection after a fault
In the event of a fault, the unit
switches off and does not switch on
again automatically. After clearing
the fault, the unit can be switched
on again by setting the control
switch to “0” and waiting for
about30 seconds.
Multiple series connection
The control unit is suitable for
multiple series connection. Several
motors in the same circuit can be
connected to a control unit.
The total rating of the connected
S1 = Control switch K1 = Contactor R1 = PTC element
F1 = Control fuse H1 = Indicator light