REMKO CLK 80-RV - Manual (Page 11)

11
1. Move the operating
switch to the "0"
(off) position.
2. Shut off fuel
supply.
3. With longer periods
of inactivity, disconnect the
units from the mains power
supply.
Ventilate
In this switch position the supply
air fan runs permanently.
The units can be used for air
recirculation or ventilation
purposes.
1. Move the operating
switch to the "II"
(Ventilate) position.
Thermostatic control as well
as heating operation is not possible
in this operating mode.
Heating with room thermostat
(Accessories)
The units operate fully
automatically and exclusively
in accordance with the room
temperature.
1. Pull out the strapping plug [2].
2. Connect the room thermostat
[4] plug [3] with the thermostat
receptacle [1] on the unit.
3. Place the room thermostat
[4] at a suitable location
in the room.
The thermostat sensor must not
be located directly in the warm
air flow and should also not be
placed directly on the cold floor.
4. Set the desired temperature
on the room thermostat [4].
5. Move the operating
switch to the "I"
(Heating) position.
The unit starts automatically after
a brief burner pre-ventilation
if heat is required and then runs
fully automatically.
Shutdown
3
1
4
AttEntiOn
Never interrupt the power
supply prior to the completion
of the follow-up cooling
phase.
There is no warranty claim
for damage to the units from
overheating.
nOtE
Indicator light "Operation"
The indicator light signals the
"Heating" operating mode.
There is no display in the
"Ventilate" operating mode
or with the room thermostat
switched off and when the STB
has been triggered.
AttEntiOn
The thermal overcurrent relay
must be operated exclusively
in the "Manual resetting"
position. It is not permitted for
the relay to be able to switch
itself back on again after
the cooling down phase.
nOtE
If the overcurrent relay
is operated in the "Automatic
resetting" position, then motor
damage cannot be excluded.
Guarantee claims are voided!
nOtE
The burner setting should be
checked after every change of
location and adapted to the
new environmental conditions
and atmospheric conditions if
necessary.
The supply air fan runs on
to cool the combustion chamber
and the heat exchanger and only
switches off after the cooling
down phase is complete.
The fan can switch on and run
several times before the final
shutdown.