Posiflex JIVA KS-7717 - Manual (Page 8)

Part 8
DISCONNECTING ALL CABLES
After removal of the cable cover, the connector area will be accessible then.
Please first note orientations of every existing cable connection and then
disconnect every cable properly before separating the main unit from the
adjustable stand assembly. Please note that the click lock spring has to be
pressed down prior to pulling out the connector such as the LAN port or the
CR port or the alternate RJ45 port. Please also note that the fixing screws have
to be loosened free prior to disconnection such as the regular DB9 COM ports
or the VGA port. Please always hold the connector head instead of pulling
on the cable wire when disconnecting any connector. Failure to do this could
damage the cable and jack that is considered as an artificial destruction.
Damages due to incorrect disconnection operation are not covered by
product warranty!
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system, all the
cable connections have to be routed through its base. Therefore, please observe
the procedures from A to C below to separate the main unit from the slim base
stand assembly after all cables in cable cover disconnected.
Step A: Prepare a soft clean flat surface, such as a piece of cloth on the desk to
seat the front surface of main unit
Step B: Press the Lock/Release button for main unit detach and meantime.
Step C: Slide the base stand assembly to right to separate the main unit from
base stand.
A B