Posiflex JIVA KS-7717 - Manual (Page 17)

Part 17
Wake System with Fixed Time/Wake Systems with Dynamic Time and Wake
on Ring.
To enable Wake System with Fixed /Dynamic Time,
1.
Press Del on system startup to access BIOS setup.
2. On Advanced tab, at Wake system with Fixed time or Wake system
with Dynamic time, select Enabled and set a specific time for the
system to wake on.
To enable Wake on Ring,
1.
Press Del on system startup to access BIOS setup.
2. On Chipset tab, select PCH-IO Configurations.
3. On the bottom of the list, select to enable Wake on Ring.
BRIGHTNESS CONTROL
In the left side of the main unit below the power switch, there are brightness
adjust push button switches and one USB connectors. Each single press on the
+ or – button changes the LCD panel display brightness by a small amount.
When you press and hold the button the change will keep on until release or
extreme condition matched. For those control buttons, please refer to the
previous chapter.
USB PORTS
There are in total 7 USB ports for external connection: 1 on left side below
power switch and LCD brightness adjust buttons; 6 on I/O area. All of them
comply with USB 2.0 standard.
DISPLAY ISSUES
Main LCD Display
For best viewing result please set your display resolution at 1024 x 768 for 15”
LCD with high color. The system Video Memory is shared from system
memory. The video graphics support DVMT 5.0
VGA Port
The VGA port supports either a separately connected LCD monitor or touch
monitor. To support the DC power to the Posiflex LCD display, have a
qualified technician to set the power supply in KS main unit through the VGA
connector according to Posiflex technical information. Do not connect other
brand monitor to this port before the power in this port is disabled.