Posiflex JIVA KS-7717 - Manual (Page 18)

Part 18
Note: When 2
nd
display is connected, the screen display of system boot up
stage and application in some OS will be smaller than both usual 1
st
and 2
nd
displays.
SERIAL PORTS – COM1/2/3/4
For this terminal, there are 3 serial ports in form of DB 9 male connectors and
one in 10-pin RJ45 connector. These serial ports can supply +5 V or +12V DC
after proper BIOS setup (for +5V DC) and jumper settings (for +12V DC) to
support Posiflex POS peripheral devices. However, do not connect any other
brand device to this port before the power in this port is disabled.
PARALLEL PORT (Optional)
For this terminal, the parallel port can be available only through use of the
optional conversion cable. It should be connected to the special connector
inside the service window as described earlier. The other end of the cable is the
normal 25 pin D sub female LPT connector.
TOUCH PANEL
All paragraphs below are applicable for models with touch panel only. The
user of those models without touch panel can ignore them and consider this
user’s manual ends here.
Mouse Emulation
When the touch driver is properly installed, this touch panel works exactly like
a standard mouse for each interface. However, if the system is running under
safe mode, the touch panel calibration may become unsatisfactory due to
disabled drivers. It is recommended to use a standard USB mouse or keyboard
in this mode.
All the below mentioned mouse emulation functions can be manipulated
through relevant software. The system can give a beep and a click on the left
button of a mouse at the point when the touch panel is touched. If the point
touched is dragged across the screen surface, it works as the mouse drag and
drop feature. If the point is touched, released and touched within a short time
interval, it is double-clicking left button of the mouse. To obtain the effect like
clicking on the right button of a mouse, touching any point on the screen
surface after touching the right-click sticky button results as a click on the right
button of the mouse at that point.
Touch Manager
Touch Terminal Manager for each type of touchscreen is available for user to
set up touchscreen functions. If your system is preloaded with the OS of your
choice, the chances are the Manager is already installed on your system.