Posiflex JIVA KS-7717 - Manual (Page 12)

Part 12
CONNECTING CASH DRAWER (OPTION)
The RJ11 connector in I/O area of the terminal can be used for controlling
most of the common cash drawers available on the market. However, it is most
recommended to use Posiflex CR-2200 or CR-2210 or CR-3100 or CR-4000
or CR-4100 or CR-6300 for best compliance to operate the opening
mechanism and to monitor the drawer open status.
This cable of Cash Drawer has a 6-pole plug at one end and an 8-pole plug at
the other. The 8-pole plug should be inserted into the connector of the cash
drawer which marked “Signal”. The 6-pole plug should be inserted in the
connector marked “CR” which can be found in the main connection area in the
system.
The user may also purchase the optional 2-in-1 cash drawer control cable to
control 2 cash drawers in 1 port. It has a 6-pole plug at one end and two 8-pole
plugs at the other. The 6-pole plug should be inserted in the connector marked
“CR” found in the I/O area in the system. Each 8-pole plug should be inserted
into the connector marked “signal cable from POS Printer” at the rear of one of
the cash drawers.
CONNECTING CABLES
To have the re-assembled main unit with stand assembly ready for operation,
please connect all required cables to the appropriate connectors. Please make
sure that each connector is connected to the correct port with the correct
orientation. Damages due to incorrect connection or orientation are not
covered by product warranty!
Some connectors like the 10-pin RJ45, LAN or CR connector have to be
gently inserted until a click sound is heard. It is recommended that connectors
such as the RS232 and VGA connector be screwed into place once seated.
Re-adjust the tilt angle of the screen for best viewing. Connect the cables to
appropriate external devices through the cable exit at the bottom of stand
assembly. Please make sure that each connector has to be connected to the
right device in the right way.