Philco PHBM 7000 - Manual (Page 12)

10 Revison 06/2014 Copyright © 2014, Fast ČR, a. s.
EN
PART 7: BAKING TROUBLESHOOTING GUIDE
No. Problem Cause Solution
1.
Smoke is escaping
from the vents
during baking.
Some ingredients got stuck to the
heating element or they got close to
it. If this happen during the fi rst use, it
may be caused by oil burns that stayed
on the surface of the heating element.
Disconnect the bread maker from
the power supply and clean the
heating element. Use caution to
prevent burns. During fi rst use, dry
the machine by switching it on and
starting baking programme. Keep the
lid open.
2.
The bottom crust is
too thick.
You are using the bread warming
function, and leaving the bread in the
machine for too long. That causes water
loss and drying, mainly on the bottom.
Take the bread out earlier and do not
use the warming function.
3.
The bread could
be removed from
the container with
diffi culties only.
The kneader is stuck to the shaft inside
the baking container.
After you remove the bread, fi ll the
baking container with warm water
and submerge the kneader in it for
about 10 minutes. Then remove it and
clean it thoroughly.
4.
The ingredients
are not thoroughly
mixed and the
baking is not
satisfactory.
1. Incorrectly selected programme.
Select other, more suitable
programme.
2. After you started the programme,
you have opened the lid several
times; the bread is dry and the crust
is too light - not crispy. Do not open the lid during the last
rising period.
3. The resistance during the mixing
is too big, the kneader is barely
moving and not mixing all
ingredients well.
Inspect the hole in the kneader.
Remove the baking container and turn
on the kneading process without the
dough. If the appliance does not seem
to work properly, contact authorized
service centre.
5.
After you have
pressed the „Start/
Stop” button the
display shows
„H:HH”.
The inner temperature in the bread
maker is too high.
Press the „Start/Stop” button and
disconnect the machine from the
wall outlet. Then remove the baking
container, open the lid and let the
bread maker cool down.
6.
You can hear the
motor running but
the dough is not
being kneaded.
The baking container is incorrectly
attached or the volume of the dough is
too big for the mixing.
Inspect whether the baking container
is correctly attached, if the dough was
prepared according to the correct recipe
and if all ingredients were weighted
properly.