To set the beep, View system information – OWON AG1022 User Manual
Page 33
5.Front Panel Operation
confirm. All the settings will be set to default. The default settings of the system are as
follows:
Output
Default
Function
Sine Wave
Frequency
1kHz
Amplitude/Offset
1 Vpp / 0 Vdc
Waveforms
Default
Frequency
1kHz
Amplitude
1Vpp
Offset
0Vdc
Duty Cycle of Square
50%
Symmetry of Ramp
50%
Pulse Width of Pulse
200us
Duty Cycle of Pulse
20%
Others
Default
Brightness
95%
Separator
Comma
Screen Saver time
100 minutes
Baud Rate
115.2K
Load
High Z
Phase Deviation
0°
Clock Source
Internal
Channel Output Control
Off
To Set the Beep
(1)
Press Utility and choose System, enter the second page of the menu.
(2)
Press F1 to select Beep.
(3)
Press F1 to switch between On/Off. On is to activate the sound when the system
informs you. Off is to deactivate it.
View System Information
(1)
Press Utility and choose System, enter the second page of the menu.
(2)
Press F2 to select Sys info. You can view the Version and Serial number.
28