OWON AG1022 - Manual (Page 23)

5.Front Panel Operation
Figure 5-9: Set the Pulse Width of Pulse signal
To Output Noise Signals
The noise signal which the generator output is white noise. Press button to call the
user interface of Noise signal, the Noise waveform parameters can be set by operating
the Noise setting menu on the right.
The parameters of Noise waveform are: Amplitude/High Level, Offset/Low Level. You can
operate the menu by using the menu selection buttons on the right.
To set the Amplitude/High Level, Offset/Low Level, please refer to "To Output Sine
Signals" on P12.
Setting menu
of Noise signal
Amplitude
Load
Offset
Current signal
Channel
Parameter 2 Parameter 3
Noise waveform
Figure 5-10: The User Interface of Noise Signal
To Output Arbitrary Signals
Press button to call the user interface of Arbitrary signal, the Arbitrary waveform
parameters can be set by operating the Arbitrary setting menu on the right.
The menu items of Arbitrary waveform are: Frequency/Period, Amplitude/High Level,
18