OWON AG1022 - Manual (Page 11)

4.Quick Start
⑪ Foot stool Make the instrument to be tilted for ease of operation
⑫ CH1 Output Control Turn on/off the output of CH1. The backlight will be lighted
when CH1 is tuned on.
⑬ CH1 Output Output signal of CH1
⑭ CH1/2 button Switch channel displayed on the screen between CH1 and
CH2.
⑮ DC button Enter DC settings screen of current channel
⑯ Both button Display the editable parameters of both channels. When the
function is enabled, the backlight of the button turns on.
⑰ Waveform selection
buttons
Include: Sine , Square , Ramp , Pulse ,
Noise and Arbitrary waveform. When a
waveform is selected, the backlight of the button turns on.
⑱ Power button Turn on/off the generator
Rear Panel
① ② ③ ④
⑧ ⑦ ⑥
⑤
Figure 4-2 Rear panel overview
①
②
20MHz reference
output
20MHz reference
input These two connectors are used to synchronize generators.
The connector [20MHz In] accepts an external 20 MHz
clock signal, and the connector [20MHz Out] can output a
20 MHz clock signal generated by the crystal inside the
generator. (See P29, "To Set the Clock Source")
③ RS232 port Through this interface, the generator can be connected to
a PC and controlled via PC software.
④ Power socket AC input connector
6