OWON AG1022 - Manual (Page 20)

5.Front Panel Operation
Figure 5-5: Set the Duty cycle of Square signal
To Output Ramp Signals
Press button to call the user interface of Ramp signal, the Ramp waveform
parameters can be set by operating the Ramp setting menu on the right.
The parameters of Ramp waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Symmetry. You can operate the menu by using the menu selection
buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "To
Output Sine Signals" on P12.
The frequency range is 1μHz～1MHz; the period range is 1us～1Ms.
Channel
Setting menu
of Ramp signal
Amplitude
Load
Offset
Current signal
Frequency
Parameter 1
Symmetry
Parameter 2 Parameter 3
Figure 5-6: The User Interface of Ramp Signal
15