ONICON System-10 P1 - Manual (Page 5)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 5
SECTION 1.0: INTRODUCTION
1.1 PURPOSE OF THIS GUIDE
The purpose of this guide is to provide installation and commissioning procedures and basic
operating and servicing instructions for the ONICON SYSTEM-10 BTU Meter equipped with a
Siemens Floor Level Network Communications Driver and Point Database.
NOTE: Also refer to Siemens’ Application Note, Document No. 140-0280.
1.2 TYPICAL SYSTEM-10 BTU METER
ONICON’S System-10 is a true heat (BTU) computer, which accepts data from several sensors,
performs a series of computations with that data, and displays and/or transmits the results as an
indication of the amount of heat (BTU’s) being transferred per unit time or as a totalized amount.
!
1.3 STANDARD FEATURES AND SPECIFICATIONS
• Single mode BTU calculations, in either the heating or cooling mode, are totalized,
displayed and reported to the P1 network.
• Two-pipe dual mode BTU calculations in both the heating mode and the cooling mode are
totalized, displayed and reported separately to the P1 network.
• B-directional dual mode BTU calculations are totalized, displayed and reported separately
to the P1 network.
WARNING
Only qualified service personnel should attempt to install or service this product. Serious injury
may result from the improper unstallation or use of this product.