ONICON System-10 P1 - Manual (Page 30)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 30
DUAL MODE BTU METERS
PAGE NUMBER DISPLAY NAME SELECTABLE UNITS
1 MODE 1 ENERGY TOTAL BTU, TONHR or KWHR
2 MODE 1 VOLUME TOTAL GAL, LITER, METERS 3
3 MODE 2 ENERGY TOTAL BTU or TONHR
4 MODE 2 VOLUME TOTAL GAL, LITER, METERS 3
5 ENERGY RATE BTU / HR, TONS or KW
6 VOLUME RATE GPM, GPH, MGD, L/SEC, L/MIN,
L/HR, METERS 3 /HR
7 SUPPLY TEMPERATURE DEG F, DEG C
8 RETURN TEMPERATURE DEG F, DEG C
9 DIGITAL INPUT Di3 NONE
The operating mode, measurement units and multipliers are programmed into the BTU meter at
the factory. These settings may be re-programmed in the field. Please contact ONICON technical
support personnel for assistance, if changes are required.
4.3 UNITS AND MULTIPLIERS
The units and multipliers are programmed prior to delivery. Contact ONICON for assistance in
changing units or multipliers.
4.4 ANALOG OUTPUTS
The System-10 BTU Meter is capable of providing up to four analog outputs (optional). Analog
outputs are programmed at the factory in terms of units and scaling. Changing any of the
displayed units or multipliers will affect the analog outputs. If any unit or multiplier values are
changed at the System-10 BTU Meter, the analog output value(s) will also be changed. If you are
unsure of the ramifications of any changes you are contemplating, please contact ONICON for
assistance.