ONICON System-10 P1 - Manual (Page 16)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 16
Connect the power source to the main unit through the conduit opening located on the
bottom of the main unit. Fasten the power wires to the appropriate screw terminals as
shown. Do not exceed 13 in-lb (1.5 Nm) of torque when tightening.
As power is initially applied to the System-10, immediately confirm that the power light is
illuminated and the display is scrolling through the character diagnostic test. The test will
begin by indicating the letter P in every position followed by a countdown from 9 to 0 for
each digit, If this does not occur, disconnect power immediately and re-verify all wiring
connections. If the problem persists, contact ONICON.
J1
5
G 60HZ
1
J2-1
+15 +24
J2-12
G G
10
R7
H3
R1
20075-50 REV. A
LED1
T1
D1
D2
VAR1
F1
TB1
D4
D3
H1
1
R1
20075-50 REV. A
F1
TB1
L1 N
Not Used
1/4 AMP
1/4 AMP
L1 N Not Used
WARNING
Disconnect mains power before proceeding.
!
!
WARNING
Connect the protective earth wire to the lug located in the lower left hand corner of the motherboard.