Nortec LINKS 2 NHRS - Manual (Page 8)

4 | Installation
Wiring The Nortec Links2 Module
Most of the wiring connections for the new Nortec Links2 module will have already been finished
at the factory, however, there is an additional Logic Card that must be installed. Refer the LINKs 2
wiring diagram included in the package for added details.
Module Power Connections
There will be a wire harness provided that will consist of a red and blue wire. Both red and blue
wires are terminated ring terminals. Cut the terminals off and strip off 1/8” insulation on the end.
1. The red wire is to be connected to the left side of contact #1 (24v) on the main terminal strip.
The blue wire is to be connected to the left side of contact #3 (ground) on the main terminal
strip.
Figure 4. Humidifier Main Terminal Strip