NCast PR-HD - Manual (Page 73)

NCast Presentation Recorder Reference Manual
If the Presentation Server scheduler will not be used, uncheck this box to save unneeded network activity.
7.8.3. Server/Port
Enter the server address and access port.
7.8.4. Use SSL
Check if communications with the server is required to use SSL protocol.
7.8.5. Capture Agent Name
The unique name for this encoder to be used when registering with the server.
7.8.6. Username
The account name used by Capture Agents to log into the server. Usually the system account.
7.8.7. Password
The password for the system account.
7.8.8. Media Flavor
The default tag/flavor to use for the uploaded media.
7.8.9. Serial command
This entry specifies the serial command which will be used to start a Channel when a scheduled event is
activated.
7.8.10.Troubleshooting the PS Installation
Use the following checklist if there are problems in getting the encoder to work with the server:
1. On the Configuration-->Presentation Server tab double check that the correct server address, port
and credentials have been entered. Try the Connection Test and/or view the upcoming Schedule. At
this point the encoder should be registering as a Capture Agent and its status should be visible on
the server's Capture Agent page.
2. There is no Capture Agent configuration required on the server. The Capture Agent simply registers
with the server and tries to pull down its upcoming schedule. If there is no status visible, make sure
that the encoder's DNS settings are correct and that there is no firewall blocking the ports (often
8080) used to communicate with the server. Make sure each Capture Agent has its own unique
name. Getting the encoder to register with the server is a critical step and must completed for
anything else to work.
NCast Corporation Revision 2.2
Page 73