Montigo RX200 - Manual (Page 7)

Installation
Page 7 XT0016 - 092214
F. Operation with Backup Battery:
1. Install the four supplied AA batteries to the battery holder.
CAUTION: Please note battery orientation while installing them.
Incorrect orientation may damage battery, cause fire hazard and the
fireplace may not function properly.
2. Follow the instructions on the "Proflame2 Operation and Main-
tenance Manual- XG0677" to install batteries on the remote
control.
3. Turn the gas supply ON.
4. Program the remote control to the control module
(see "Pro-
flame2 Operation and Maintenance Manual- XG0677").
5. Check the stepper motor for gas leaks and ensure no leak.
6. Turn the fireplace ON and modulate the flame using the remote
control and ensure proper operation (see "Proflame 2 Opera-
tion and Maintenance Manual XG0677").
G. Operation with MAIN Power:
1. Remove the four batteries from the battery holder
2. Plug the Control Module Power cord to the PPO box. See
Figure 3.
3. Turn the fireplace ON using the remote control and confirm
operation with main power ON.
Note: You may re-install the backup batteries to the battery holder at
this point to ensure that fireplace is operational during power outage.
It is recommended to check and replace the backup batteries at least
once a year. More frequent battery replacement may be required in
case of extended operation on backup batteries.
E. Battery Holder Installation:
1. Secure the battery holder to the fireplace floor using the supplied
velcro strips. See Figure 21.
Note: The velcro strips act as an electrical isolation, do not attach
the battery holder to any metal part without using the velcro strips, or
the control module will be damaged.
2. Connect the red and black wires from the battery holder to the
red and black wires from the valve harness. See Figure 22.
Figure 21 Battery holder
Figure 22 Battery holder wires
Blue Back lit LCD display
On/Off Key
Thermostat Key
Up/Down Arrow Key
Mode Key
Figure 23 Proflame Remote Control