Montigo RX200 - Manual (Page 3)

Installation
Page 3 XT0016 - 092214
A. Disconnect Control Module and Harness:
1. Disconnect Control Module Powercord from the PPO box.
Figure 3 Powercord in PPO box
Figure 4 Control module with wires
2. Disconnect Spark Wire and Sensor Wire from connec-
tors X2 and X3 of the control module.
3. Disconnect the wall switch harness from X4 Control
Module and discard.
4. Remove the Valve Harness from X5 of the control module.
5. Remove the connector from X1 of the control module.
6. Remove the control module from firebox compartment and
discard. Note: module is attached by velcro strips.
Figure 5 X5 plug of control module
Figure 6 X1 plug of control module