Montigo H38DF-CLCR - Manual (Page 22)

Page 22 XG0213 - 150204.2
H*38DF-CLCR Corner Gas Fireplace
Installation
Section 7: Screen Installation and Removal
Screen Bottom
Tabs
Screen Tab
Receptacles
Upper Screen
Studs
Upper Screen
Stud Catch
Left Side Detail
Left Side Detail
Removing / Attaching
The Safety Screens
To Remove the screen(s)
Simply grasp each top
outer corner of the screen
with your thumb and
finger and pull towards
you. Once the upper
Screen Studs are free, at
an angle, lift the screen
from the lower slots in
which the Screen Bottom
Tabs are held. Place the
screen in a safe place.
To Install the Screen(s).
Holding the screens at an
angle away from the
fireplace, locate the
Screen Bottom Tabs at the
lower corners of the
screen into the Screen
Tab Recepticles in the
lower section of the
fireplace. Make sure the
tabs and screens are
lowered all the way down
into the Screen Tab
Recepticles on the
fireplace. Then push each
Upper Screen Stud at the
top corners of the screen
into the Upper Screen
Stud Catchs in the
fireplace.
Removing / Attaching Screens:
To Remove Screens:
Grasp each top outer corner of the screen with your
thumb and finger and pull towards yourself. When the
upper Screen Studs are free, lift the screen at an angle
from the lower slots from which the Screen Bottom Tabs
are held. Place the screen in a safe place.
To Install Screens:
Hold the screens at an angle away from the fireplace, and
locate the Screen Bottom Tabs at the lower corners of the
screen. Place the screen into the Screen Tab Receptacles
in the lower section of the fireplace.
Make sure the tabs and screens are lowered all the way
down into the Screen Tab Receptacles on the fireplace.
Then, push each Upper Screen Stud on the top corners
of the screen into the Upper Screen Stud Receptacles
in the fireplace.
Figure 23b� Screen Installation and Removal
Figure 23a� Fireplace with screens
1:12
DWG. NO.
SHEET 1 OF 2 WEIGHT:
H38DF-CR-SCREENS 1,2
Finish
MATERIAL
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 1/32"
TWO PLACE DECIMAL .015"
THREE PLACE DECIMAL .005"
ALL BENDS ARE ASSUMED
TO BE 90 UNLESS NOTED
OTHERWISE.
Revision / Date
Drawn by
DATE NAME
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
PROPRIETARY AND CONFIDENTIAL Y:\CADD\38\CORNER\P38-CR DF
January-14-15 1:37:10 PM
SCALE
PC
Description
H38DF-CR SCREENS 1,2
A
Revision
A
12/05/2014
Replacement Screens:
For replacement part order numbers, please refer to section
"Replacement Parts:" on page 33.
Note: Do not operate fireplace without all screens in place.