Montigo H38DF-CLCR - Manual (Page 12)

Page 12 XG0213 - 150204.2
H*38DF-CLCR Corner Gas Fireplace
Installation
Figure 9c. Rear vent, Roof mounted venting (1 = 90° bend).
Support ring
Support plate
32’ M a.x
PVTK1
Termination
*18” Max. See
Note below
Storm Collar
* Note:
Elbow must be installed directly off the back of the fireplace. If
additional horizontal distance is required the vent run must be increased
a 2:1 Horizontal to Vertical ratio. See vent graph, Figure 12 or 13 for
rear vented, wall mounted terminations
Note: Images are shown without screens for clarity purposes. However,
your fireplace should not be operated without proper installation of
screens.