MK Products Weld Control - Manual (Page 38)

Weld Control Selector Guide - Page 31
MiLLER VintaGE, MiLLERMatiC 250, HOBaRt BEtaMiG 2510
or ironMan 250
P/N 005-0205
This easy to install, plug in module fits the Millermatic 250, Miller Vintage machine,
or Hobart Betamig 2510. It and a Prince Spool Gun are all that is needed to get
your customer up and running.
fOR POWER SUPPLiES tHat SUPPLy an aUXiLiaRy 26 VaC
The PA-G1 is designed to hook-up to CV power supplies that supply an
auxiliary 26 VAC @ 1.7 amps and uses a closing contact signal. The unit is
supplied with bare wires that must be connected to the power supply. Some
examples of power supplies that can be hooked-up are:
Lincoln SP-250, 255 & Wirematic 250 & 255
Beta-Mig 200 & Beta-Mig LF
Airco Dip-Pak 200, 225 & 250
fOR POWER SUPPLiES WitH 14 Pin aMPHEnOLS
The PA-M1 connects directly to Miller power supplies (24V system) that are
classified with 14-Pin amphenols as type 6 or 9 and to Thermal Arc units,
such as:
Miller Welders
Millermatic 200 Deltawelds
Shopmaster CO Series, Regency's
XMT's & Maxtron Trailblazer 250, 251, 280, All engine-driven
welders with a CV-tap and a 14 pin amphenol.
Thermal-Arc Welders
Thermal-Arc 300GMS CC/CV, 400GMS
Fabricator 210, 250, 300 LF
The PA-L1 connects directly to Lincoln Electric power supplies (42V system) with
14-Pin (X-clocked) amphenol connectors, such as:
Lincoln Electric
Ranger 9, 10, 250, 275, 304 CV Series
Commander 300, 500 (See Note 10) Vantage 500
Invertec V300-Pro, V350-Pro (Fac. or Adv.)
Panasonic Gunslinger 260
P/N 005-0617
fabricator Series
P/N 005-0689
MillerMatic250X/251
P/N 005-0629
ESaB (L-tEC) MiGMaStER 250
P/N 005-0206
SPOOL GUn COntROLS
PA-G1
P/N 005-0264
PA-M1
P/N 005-0261
PA-L1
P/N 005-0676