MK Products Weld Control - Manual (Page 12)

WELd COntROLS aVaiLaBLE
Weld Control Selector Guide
A P/N 005-0261 PA-M1 Spool Gun Control F P/N 005-0624 MigMaster 251 Kit
B P/N 005-0264 PA-G1 Spool Gun Control I P/N 001-3062 WC-1 Control
C P/N 005-0205 MillerMatic Module J P/N 001-3066 MK200 Contactor
D P/N 005-0629 MillerMatic 250/250-X Intfc Cbl K P/N 005-0617 Gunslinger 260 Intfc Cbl
E P/N 005-0206 MigMaster 250 Module L P/N 005-0676 PA-L1 Spool Gun Control
Weld Control Selector Guide - Page 5
notes:
1. Miller power supply must have 14 pin Amphenol or the WC-1 must be used. See WC-1
hookup, section M-2.
2. Constant current (CC) power supplies can only be used in spray transfer mode with
ALUMINUM and CORED wire only.
3. These power supplies put out less than 24VAC to the spool gun therefore maximum speed will
not be obtained. This means 3/64 diameter wire should be used when welding materials thicker
than 1/4.
4. Must be used in the non "synergic" mode.
5. Contactor box not needed if power supply has optional remote control facilities (panel).
6. WC-1 Weld Control can also be used.
7. An adapter cable with Amphenol already attached can be used with the power supply and
WC–1 or Cobramatic combination.
8. Many of the newer power supplies, especially the inverter style units now use a Dinse style
connector for the weld power out. This means the lug on the power cable of the Spool-gun
must be cut-off and replaced by a male Dinse connector (MK P/N: 153-0755).
9. MK does not make a weld control for the Lincoln PowerMig 255. Since Lincoln makes their
own control for a Prince XL Spool-gun, they furnish the control module with the Spool-gun.
However the WC-1 or the MK Cobramatic Cabinet may be used with that unit (See L-7 ).
10. At this time, the Lincoln Commander 300 and 500 does not have 42VAC volts at the 14-Pin
connector. An optional kit (P/N: K1597-1) must be obtained from Lincoln in order to use the
Prince ® XL spool gun with the PA-L1. Units with a date code of November 2001 have 42VAC.
11. If the Fabricator 210 has a 4 digit specification number (xxxx), then the 14-Pin Control will
work. If the 4 digit specification has an "A" at the end (xxxxA), then a WC-1 Control must be
used. (See H-2)
12. To use an MK 003-1341 Adapter, the Multimaster 260 requires the optional ESAB spool gun
control module. Units after S/N 0558001793 come standard with the Spool Gun Module.
13. The Classic Series engine driven welder is a CC type power supply. To properly operate this
unit while welding aluminum, the CV tap is required. However, because 42VAC is unavailable
a WC-1 Weld Control must be used.