MicroE Mercury II 6000 - Manual (Page 16)

Sensor Alignment and Calibration
IM-Mercury_II_6000 Series Rev. 1 Page 15 ©2014 MicroE Systems
Mercury II 6000 Series Encoders
Installation Manual and Reference Guide
5.2.2 Use the FindMII Program to locate the Encoder
Step Action
1. Once the encoder is connected to the computer using an Ethernet cable, run the software
program FindMII (Mercury II Encoder Search Utility) version 1.2.2.1 or higher. To locate the
correct version for your operating system, go to Software Downloads at
http://www.microesys.com/products/documentation or click on one of the following links:
For Windows operating systems: FindMII.exe
For all other operating systems: FindMII.jar
2. The FindMII program locates the encoder and allows you to use the embedded SmartPrecision II
Software on your web browser.
Note: You may receive an Application Blocked by Security Settings message when
attempting to load the plotApplet. Go to the Java applet in your Control Panel and try reducing
the Security Level in the Security Tab.
Warning: Reducing the Security Level in the Security Tab may decrease protection of your
computer against malicious software.
3. Once located, the FindMII program will list all the encoders connected to the network as seen in
the following example.
4. Double-click the name of the encoder to open the SmartPrecision II Software.
Encoder
found by the
program