Microcom 470 - Manual (Page 117)

Appendix D Quick Reference Command Summary
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual 109
XX 87 Load Increment/Decrement Value Into Memory: Will load and store a step
value into non-volatile user memory. The stored serial number to be affected is
chosen with the XX variable and the actual step value, up to 9 characters, is
entered by following the ^AXX^D875 with the step value surrounded by quotes.
XX 88 Send Serial Number To Serial Port: ^A specifies which stored serial number
(1-16) to send.
XX 89 Send Increment/Decrement Value To Serial Port: ^A specifies which stored
increment/decrement value (1-16) to send.
XX 90 Enter New Combination: Uses user defined 4 digit combination to enter tech
menu instead of default 9999.
XX 91 Load Value for Printer to See Valid Gap. Section 5.3.
92 Test Printer DRAM: Printer will respond by sending a >PASS< or >FAIL<
message out communications port.
93 Load Control Code Recognition Status:
0 Enable control code recognition.
1 Disable control code recognition.
94 Send Non-Volatile User Memory Available: The printer will send the number of
free bytes to the serial port (i.e. >192480<).
XX 95 Load User Defined Steps for Label to Advance:
XX 96 Load Advance Delay: ^A specifies how many milliseconds to delay
repositioning of the label in tag/tear and peel-and-dispense modes.
97 Tag/Tear Operation: Section 2.6.1.
0 Turns off tag/tear operation.
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
98 Peel-and-Dispense Mode: Section 2.6.2.
0 Turn off peel-and-dispense mode.
1 Turn on peel-and dispense mode.
XX 101 Load Graphic Image into Non-Volatile User Memory: ^A select which volatile
slot to place the image in (1-16).
XX 102 Load Volatile Graphic Image: ^A select which volatile slot to place the image in
(1-16).