Microcom 470 - Manual (Page 114)

Quick Reference Command Summary Appendix D
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual 106
39 Auto-Size Label: Section 5.3.3.
0 Clears the use of auto-size values set by ^A1^D39.
1 Uses the values obtained instead of those in the format file.
2 Automatically sizes the label and send the results out the serial port.
3 Same as ^A2^D39, but prints the values on a label, instead of on the screen.
40 Clear Commands 41-51.
XX 41 Load number of fields in layout (HFM): Preceded by ^A.
XX 42 Load label width in dots (LSX): Preceded by ^A.
XX 43 Load label height in dots (LSY): Preceded by ^A.
XX 44 Load web size in dots (WEB): Preceded by ^A.
XX 45 Load gap size in dots (GAP): Preceded by ^A.
XX 46 Load print speed (DPS): Preceded by ^A.
XX 47 Load label control byte (LCB): Preceded by ^A.
XX 48 Load number of steps to activate gap detector (AGD): Preceded by ^A.
XX 49 Load number of steps past gap (SPG): Preceded by ^A.
XX 50 Load X direction offset (OFX): Preceded by ^A.
XX 51 Load Y direction offset (OFY): Preceded by ^A.
XX
54 Send Non-Volatile Format File to Serial Port: ^A selects which the file to be
sent (1-32). Section 5.3.6.
XX 55 Select Default Label Layout: Select from the ROM power-up layouts. ^AXX
ranges from 1 to 8.
56 End User Defined Field Definitions: Tells the printer that all field definitions are
complete.
57 Enter Label Format Mode: This tells the printer that information for a label is
following.
XX 58 Process Non-Volatile Format: ^A selects which one (1-8). Section 5.3.6.
XX 59 Save Format File: ^A selects which one (1-8). Section 5.3.6.
60 Clears command 61