Microcom 466 User Manual
Page 95
Appendix B
Quick Reference Command Summary
466 Operators Manual
89
102
Allocate XX amount of blocks for PDF Memory: The remaining blocks will be
allocated to user memory.
1
(256K) 1 block
2
(512K) 5 blocks
3
(1024K) 13 blocks
4
(2048K) 29 blocks
103
User memory configuration:
0
Send the size (in bytes) of PDF Memory to serial port 1.
1
Send the size (in bytes) of total User Memory to serial port 1. Note: This is the
total size of user memory, not the size of unused User Memory, which can still
be obtained by the ^D101 command.
105
Clear fonts and graphics: (This command is currently not implemented)
0
Clear all fonts and graphics.
1-32
Clear individual fonts and graphics. The value will determine which slot is
cleared.
106
Load Font or Graphic: The ^A value determines which slot (1-255) the font or
graphic image will be stored in.
121
Set ^D122/^D123 retract/advance speed: This command sets the speed at
which the ^D122 and^D123 commands advance or retract media. The ^A value
is specified using the print speed chart.
122
Advance media: This command causes the printer to advance the media. The
amount is set using the ^A value. Note: The printer does not automatically
retract using this command. This command is used only in special applications.
123
Retract media: This command causes the printer to retract the media. The
amount is set using the ^A value. Note: The printer does not automatically
advance using this command. This command is used only in special
applications.
160
Slew speed control: If enabled, this command will cause the printer to rapidly
advance the current label when it has completed all printing.
0
Disable slew
1
Enable slew
161
RAM checksum control: If enabled, this command will cause the printer to
verify the integrity of internal user RAM. The RAM checksum is updated each
time that a file is stored in user RAM. This command should be enabled if the
printer is equipped with the battery backed RAM option.
0
Disable RAM checksumming
1
Enable RAM checksumming