Microcom 466 - Manual (Page 46)

Printer Commands Chapter 5
466 Operators Manual 40
^A ^D COMMAND
25 Change SW5: Change software switch bank #5.
12345678
^ABxxxxxxxx
*******.) 1=XON/XOFF Enable, 0=Disable (COM2)
******.)) 1=8 Data Bits, 0=7 Data Bits (COM2)
*****.))) 1=Echo Enable, 0=Disable (COM2)
****.)))) 1=No Parity, 0=Enable Parity (COM2)
***.))))) 1=Odd Parity, 0=Even Parity (COM2)
**.)))))) 1=Ignore Control Codes, 0=Accept (COM2)
*.)))))))))),
.)))))))))),* Status Message Format (COM2)
00 = Control Codes
10 = Text Equivalent
11 = ^ Equivalent
Position:
1,2 Status Message Format (COM2): This determines what the printer will send
back in response to an enquiry. See Section 5.2.
3 Control Codes (COM2): This switch setting will allow or disallow printer
response to control codes (below 20h).
4 Parity (COM2): Selects either even or odd parity error checking.
5 Enable Parity (COM2): Enables or disables parity error checking.
6 Echo (COM2): If this feature is enabled, the printer will echo all received
characters to the serial port.
7 Data Bits (COM2): Choose 7 or 8 bit data.
8 XON/XOFF (COM2): Enable or disable XON/XOFF software handshaking.
CTS/RTS hardware handshaking is always enabled.