Microcom 466 - Manual (Page 47)

Chapter 5 Printer Commands
466 Operators Manual 41
^A ^D COMMAND
26 Change SW6: Change software switch bank #6.
12345678
^ABxxxxxxxx
*******. 1=Disable ON/OFF LINE Button, 0=Enable
******.) Not Used
*****.)) Not Used
****.))) 1=Stacker Enable, 0=Disable
***.)))) 1=Enable Cutter at Power-up, 0=Disable
**.))))) 0=Cutter Type A, 1=Cutter Type B
*.)))))) 1=Use > and # for C128 commands, 0=Use #
.))))))) 1=Enable Slew Speed, 0=Disable
Position:
1 Slew Speed Control: If enabled, the printer will rapidly advance to the end of
the label after all printing is completed. Slew speed is 12ips in direct thermal
mode and 8ips in thermal transfer mode.
2 Code 128 Command Characters: If enabled, the printer will use the > and #
characters as Code 128 command characters. If disabled, the printer will only
use the # character.
3 Cutter Type Select: If enabled, the printer will assume cutter type B (guillotine).
If disabled, the printer will assume cutter type A (rotary).
4 Cutter Status at Power-up: If enabled, the cutter will be active at power-up. If
disabled, the cutter must be enabled using the ^D99 command.
5 Stacker Status: This switch enables the optional stacker mechanism.
6 Not Used:
7 Not Used:
8 Disable ON/OFF LINE Button: If this switch is enabled, the ON/OFF LINE
Button will no longer function.
^A ^D COMMAND
XX 36 Adjust Contrast Base: This command is used to adjust print contrast base.
This command is stored in the EEPROM and skews the entire contrast window
(^D35). This command has a range of 10 to 200%.