Microcom 466 User Manual
Page 94

Quick Reference Command Summary
Appendix B
466 Operators Manual
88
XX
88
Load Field Number to Increment by 1: For multiple serial numbers.
XX
89
Load Field Number to Decrement by 1: For multiple serial numbers.
XX
90
Piezo Beep Control: Enter number of times to beep pieze before turning it off.
This setting is used to control the number of times that the pieze beeps after an
error occurs. A value of 0 will produce a continuous beep.
XX
91
Load Value for Printer to See Valid Gap. Section 5.3.
XX
92
Load Value for Slices to Process: This command adjusts the number of slices
generated before the drive motor starts moving. The default is 256 and the
valid range is 1 to 366.
93
Load Control Code Recognition Status:
0
Enable control code recognition.
1
Disable control code recognition.
94
Piezo On/Off:
0
Enable piezo.
1
Disable piezo.
XX
95
Load User Defined Steps for Label to Advance:
XX
96
Load Advance Delay: ^A specifies how many milliseconds to delay
repositioning of the label in tag/tear and peel-and-dispense modes.
97
Tag/Tear Operation:
0
Turns off tag/tear operation.
1
Advance after every label.
2
Advance after copies count.
3
Advance when idle.
98
Peel-and-Dispense Mode: Sections 2.5.2 and 5.3.7
0
Turn off peel-and-dispense mode.
1
Turn on peel-and dispense mode.
2
(Custom Applicator Mode - peel and dispense with no delay.)
99
Cutter Control:
0
Disable cutter.
1
Enable cutter.
100
Clear User RAM: This command will clear all downloaded fonts, graphics, and
stored label formats. See Section 5.3.8.
101
Send User RAM Available: The printer will send the number of free bytes to the
serial port (ie. >699842<).