beautypg.com

Microcom 226 Users Guide User Manual

Page 32

background image

Printer Modes

Chapter 4

22

226/

426 User’s Guide

4.2.3.13

>STOCK NOT LOADED< (8F)

The “>STOCK NOT LOADED<” response indicates that media is not being detected in the
printer on power up while in text and verbose response sets. If the printer is configured for
byte responses, the code ASCII 0x8F is issued from the printer in response to an enquiry
command. This message persists until media is detected at the registration mark sensors
but does not prevent commands from being processed.


4.2.3.14

>RETRACTION DELAY< (90)

The “>RETRACTION DELAY<” response indicates that the printer has been configured
with a delay before retracting, refer to the ^D641) command, while in text and verbose
response sets. If the printer is configured for byte responses, the code ASCII 0x90 will be
issued from the printer in response to an enquiry command.


4.2.3.15

>PRINT DELAY< (91)

The “>PRINT DELAY<” response indicates that the printer has been configured with a delay
between labels, refer to the ^D640) command, while in text and verbose response sets. If
the printer is configured for byte responses, the code ASCII 0x91 will be issued from the
printer in response to an enquiry command.


4.2.3.16

>FLASH MEMORY LOW< (B0)

The “>FLASH MEMORY LOW<” response indicates that the user storage area of the flash
memory is 95% full while in text and verbose response sets. This message will continue to
be received until files are removed from flash memory or until the printer performs garbage
collecting and defragmenting. If the printer is configured for byte responses, the code ASCII
0xB0 will be issued from the printer in response to an enquiry command.


4.2.3.17

>BUTTON 1 TAPPED< (C0)

The “>BUTTON 1 TAPPED<” response occurs when the ^D541) command is configured for
the “tapped” response while in text and verbose response sets. This may be used for
custom configuration and definition of the print button press or tapped condition. If the
printer is configured for byte responses, the code ASCII 0xC0 will be issued from the printer
in response to an enquiry command.


4.2.3.18

>BUTTON 1 HELD< (C1)

The “>BUTTON 1 HELD<” response occurs when the ^D541) command is configured for
the “held” response while in text and verbose response sets. This may be used for custom
configuration and definition of the print button held condition. If the printer is configured for
byte responses, the code ASCII 0xC1 will be issued from the printer in response to an
enquiry command.


4.2.3.19

>TEMPERATURE OUT OF RANGE< (D0)

The “>TEMPERATURE OUT OF RANGE<” response indicates that the printer’s print head
is not within the proper operating range while in text and verbose response sets. This
response will not allow the printer to print until the print head returns to the proper operating

This manual is related to the following products: