Microcom 226 Users Guide - Manual (Page 21)

Chapter 3 Getting Started
226/426 User’s Guide
11
3.4.1 Front Panel Button
Operation Description
Printing a
label.
A button press while the printer is idle or paused will reprint the
last label or after a cold start, a power up label will print.
Note: If a power up label has not been enabled or if one does not
exist, the printer will print a blank label.
Printer Pause. A brief-button press while printing will cause the printer to pause.
Note: Press the button again to continue printing.
Feeding
Labels.
Hold the button down while the printer is idle to feed labels. The
printer will continue feeding labels until the button is released.
Table 4 Front Panel Button Description
3.4.2 Indicator Light
Light Color Description
Solid Green. Indicates that the power is on, the printer is in a ready state, and
is either in LOCKOUT or BASIC access levels.
Solid Amber.
Indicates that the printer is busy or is in a tag/tear mode other
than Advance When Idle (3).
Solid Red.
Indicates that the printer is either in SERVICE, FACTORY, or
DEVELOPER access levels.
Flashing
Amber.
Indicates that the printer is paused.
Flashing
Red.
Indicates an error has occurred. The printer will remain in this
state until the condition is removed.
Note: Refer to Chapter 7: Troubleshooting for helpful hints.
Alternating
Green/Amber.
Indicates that the printer is Initializing the RAM memory.
Alternating
Amber/Red.
Indicates that the printer is updating or loading a new code
revision to Flash memory.
Table 5 Indicator Light Description