Metz MECABLITZ 58 AF-2 digital Canon User Manual

Page 142

142

Adjusting the settings for slave group C
• Press the

key repeatedly until C or C TTL (for slave group C) appears on

the LC display.

• To activate slave group C, press the

key repeatedly until C or C TTL (for

slave group C) appears on the LC display. While C TTL is displayed, the

and

keys can be used to adjust the flash exposure correction value for the slave

flash units in group C, from -3 f-stops (EV) to +3 f-stops (EV) in 1/3 increments.

• To deactivate slave group C, press the

key repeatedly until only C

appears on the LC display.

• Press

to save your settings. If the key

is not pressed, the settings will be

saved automatically after approximately 5 seconds.

The settings for the slave group C are visible only as they are being enter-
ed, as the system does not allow them to appear on the display panel of
the master flash unit after they have been saved.

Setting the remote channel

• Press the

key repeatedly until "Ch" flashes on the LC display.

• Set the remote channel using the

and

keys.

• Press

to save your settings. If the

key is not pressed, the settings will be

saved automatically after approximately 5 seconds.

Setting the zoom position of the reflector
• Press the

key repeatedly until "Zoom" appears on the LC display.

• Set the zoom position using the

and

keys.

• Press

to save your settings. If the key

is not pressed, the settings will

be saved automatically after approximately 5 seconds.

Adjusting the settings for the master flash unit
• Press the

key repeatedly until M or M TTL (for master flash unit) appears

on the LC display.

Para

–

Para

–

Para

☞

Mode

–

Mode

Para

• To activate the master flash unit, press the

key until M TTL appears on

the LC display. While M TTL is displayed, the

and

keys can be used

to adjust the flash exposure correction value for the slave flash units of group
A, from -3 f-stops (EV) to +3 f-stops (EV) in 1/3 increments.

• To deactivate the master flash unit, press the

key until only M appears

on the LC display.

• Press

to save your settings. If the key

is not pressed, the settings will

be saved automatically after approximately 5 seconds.

Canon manual remote
Adjusting the settings for slave group A

• Press the

key repeatedly until A (for slave group A) appears on the LC

display.

• While A is displayed, press the

key repeatedly until M (manual remote)

appears in the display next to the A.

• While A M is displayed, the

and

keys can be used to adjust the par-

tial light output setting for the slave flash units of group A, from 1/1 to 1/128.

Adjusting the settings for slave group B
• Press the

key repeatedly until B M (for slave group B) appears on the LC

display.

• While B M is displayed, the

and

keys can be used to adjust the par-

tial light output setting for the slave flash units of group B, from 1/1 to 1/128.

Adjusting the settings for slave group C
• Press the

key repeatedly until C or C M (for slave group C) appears on

the LC display.

• To activate slave group C, press the

key repeatedly until C M (for slave

group C) appears on the LC display. While C M is displayed, the

and

keys can be used to adjust the partial light output setting for the slave

flash units of group C, from 1/1 to 1/128.

–

Mode

Para

–

Para

–

Mode

Para

Mode

–

Mode

709 47 0210.A3 58 AF-2 Can 20.06.2011 16:30 Uhr Seite 142