Metz MECABLITZ 58 AF-2 digital Canon User Manual

Page 131

131

7.8 Meter-Feet changeover (m/ft)

The maximum flash range indicated by the flash unit’s display can either be
shown in meters or feet. The setting can be adjusted under the menu option m/ft.
Setting procedure:

• Press the

button repeatedly until „Select“ appe-

ars on the display.

• Select the „m/ft“ menu option by pressing the

and

keys. The selected menu option will be

highlighted.

• Confirm the selection of the special function by pres-

sing the

button.

• Select the desired setting with the

and

keys. The setting takes effect immediately.

- When „m“ is displayed, distances will be

shown in meters.

- When „ft“ is displayed, distances will be

shown in feet.

• Press the button

repeatedly until the display is reset to its normal state. If

the button

is not pressed, the display is automatically reset to its normal

view after about 5 seconds.

Set

Sel

7.9 Secondary reflector

The secondary reflector i is used for frontal brightening in the case of indirect
lighting when the main reflector is pivoted to the side or upwards (see 10.3).

If the secondary reflector ቪ produces too much light, it can be reduced to 1/2

or 1/4 .
• „

Off“ setting: Secondary reflector is turned off.

• „

P1 / 1“ setting: secondary reflector is operating at full light output.

• „

P1 / 2“ setting: secondary reflector is operating at 1/2 light output.

• „

P1 / 4“ setting: secondary reflector is operating at 1/4 light output.

When the secondary reflector is activated and the setting is saved, a symbol
will appear in the display.
Setting procedure:
• Press the

button repeatedly until „Select“

appears on the display.

• Select the menu option

by pressing the

and

keys. The selected menu option will be highligh-

ted.

• Confirm the selection of the special function by pres-

sing the

button.

• Select the desired setting with the

and

keys. The setting takes effect immediately.

• Press the button

repeatedly until the display is

reset to its normal state. If the button

is not pres-

sed, the display is automatically reset to its normal
view after about 5 seconds.

Please also refer to the information in
Section 10.3!

☞

Set

Sel

Select

Zoom Ext

AF-BEAM

m/ft

Set

☛

Set

☛

F 4.5

AZoom 70

14 m

Select

Beep

Mode

Para

Sel

☛

1/1

Set

☛

F 4.5

AZoom 70

14 m

709 47 0210.A3 58 AF-2 Can 20.06.2011 16:30 Uhr Seite 131