Measurement Computing PC104-DAS16JR/12 - Manual (Page 5)

1 INSTALLATION
1.1 SOFTWARE
Before you open your computer and install the board, install and run InstaCal™, the
installation, calibration and test utility included with your board. InstaCal™ will guide
you through switch and jumper settings for your board. Detailed information
regarding these settings can be found below. Refer to the Software Installation manual
for InstaCal™ installation instructions.
1.2 HARDWARE
The PC104-DAS16Jr/12 has one bank of switches, two single function switches and
one jumper block which must be set before installation of the board inside your
computer (Figure 1-1). The PC104-DAS16Jr/16 has one additional switch for
selecting unipolar or bipolar ranges (Figure 1-2).
Figure 1-1. PC104-DAS16Jr/12 Switch & Jumper Locations
1
A D D R E S S
D IP S W ITC H E S
300h D efault
D M A LE V E L
S E LE C T S W ITC H
C RY STAL O S C .
FR EQ . S E LE C T
JU M P E R
1 or 10 M H z
(1=U P)
8 or 16 C H A N N E L S ELE C T
SW ITC H
P IN 1
(U N D E R )