Measurement Computing DAQFlex - Manual (Page 40)

DAQFlex Message-based Firmware Specification Hardware Reference – USB-7202
40
USB-7202
Use the components below to set or get device properties.
Refer to the DAQFlex Software User's Guide for a description of each component and property.
Component Supported
Property/Command Set/Get Supported Values
AI{ch}
OFFSET Get 4-byte floating point numeric
RANGE Set/Get BIP10V, BIP5V, BIP2V, BIP1V
SLOPE Get 4-byte floating point numeric
VALUE Get Unsigned integer numeric
AISCAN
EXTPACER Set/Get
ENABLE/MASTER, ENABLE/SLAVE,
DISABLE
HIGHCHAN Set/Get 0 to 7
LOWCHAN Set/Get 0 to 7
RANGE
Set/Get BIP10V, BIP5V, BIP2V, BIP1V
RANGE{ch}
SAMPLES Set/Get
0 to N
(0 = continuous scan; N = 32-bit)
RATE Set/Get 0.596 to 50,000 Hz (1 channel)
STALL Set/Get ENABLE, DISABLE
START
STATUS Get IDLE, RUNNING, OVERRUN, INTERRUPTED
STOP
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO, BURSTIO
AITRIG TYPE Set/Get EDGE/RISING, EDGE/FALLING
CTR
START
STOP
VALUE
Set 0
Get 0 to 4,294,967,295
DEV
DATATYPE Set/Get ENABLE, DISABLE
FLASHLED/{n} Set 0 to 255
FWV Get MM.mm (M = major; m = minor)
ID Set/Get Up to 56 characters
MFGCAL Get yyyy-mm-dd HH:MM:SS
MFGCAL{item} Get YEAR as yyyy; 20xx
MONTH as mm; 01 to 12
DAY as dd; 01 to 31
HOUR as HH; 01 to 23
MINUTE as MM; 01 to 59
SECOND as SS; 01 to 59
MFGSER Get Up to 8 hexadecimal digits
RESET/{value} DEFAULT, SYSTEM
DIO
DIR
Set IN, OUT
Get
0 to 255 (bit field: 0 = all output,
255 = all input)
VALUE Get
0 to 255 (port)
0 to 1 (bit)