Measurement Computing DAQFlex - Manual (Page 26)

DAQFlex Message-based Firmware Specification Hardware Reference – USB-1408FS-Plus
26
USB-1408FS-Plus
Use the components below to set or get device properties.
Refer to the DAQFlex Software User's Guide for a description of each component and property.
Component Supported
Property/Command Set/Get Supported Values
CAL Set/Get ENABLE, DISABLE
CHMODE Set SE, DIFF
RANGE Set/Get BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V (differential
mode)
BIP10V (single-ended mode)
RES Get U14
AI{ch}
OFFSET Get 4-byte floating point numeric
RANGE Set/Get
BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V (differential
mode)
BIP10V (single-ended mode)
SLOPE Get 4-byte floating point numeric
VALUE Get Unsigned integer numeric
AIQUEUE
CLEAR
COUNT Get 0 to 8 elements
AIQUEUE{element}
CHAN Set/Get
element: 0 to 7 single-ended;
0 to 3 differential
value: 0 to 7 single-ended; 0 to 3
differential
RANGE Set/Get
element: 0 to 7 single-ended;
0 to 3 differential
value: BIP20V, BIP10V, BIP5V, BIP4V,
BIP2PT5V, BIP2V, BIP1PT25V, BIP1V
(differential mode)
BIP10V (single-ended mode)
AISCAN
EXTPACER Set/Get ENABLE/MASTER, ENABLE/SLAVE
HIGHCHAN Set/Get 0 to 7 single-ended, 0 to 3 differential
LOWCHAN Set/Get 0 to 7 single-ended, 0 to 3 differential
QUEUE Set/Get ENABLE, DISABLE
RANGE
Set/Get
BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V (differential
mode)
BIP10V (single-ended mode)
RANGE{ch}
RATE
Set/Get 0.014 S/s to 48 kS/s
SAMPLES Set/Get
0 to N
(0 = continuous scan; N = 32-bit FIFO)
STALL Set/Get ENABLE, DISABLE
START
STATUS Get IDLE, RUNNING, OVERRUN
STOP
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO
AITRIG
REARM Set/Get ENABLE, DISABLE
TYPE Set/Get
EDGE/RISING, EDGE/FALLING,
LEVEL/HIGH, LEVEL/LOW