Measurement Computing DAQFlex - Manual (Page 32)

DAQFlex Message-based Firmware Specification Hardware Reference – USB-1608G Series
32
Component Supported
Property/Command Set/Get Supported Values
RESET Set
SAMPLES Set/Get
0 to N
(0 = continuous scan; N = 32-bit)
STALL Set/Get ENABLE, DISABLE
START
STATUS Get IDLE, RUNNING, OVERRUN
STOP
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO
AITRIG
REARM Set/Get ENABLE, DISABLE
TYPE Set/Get
EDGE/{condition}, LEVEL/{condition}
condition:
RISING, FALLING when TYPE is EDGE
HIGH, LOW when TYPE is LEVEL
AO
1 RES Get
D/A resolution
U16 (unsigned 16-bitinteger)
AO{ch}
1
OFFSET Get 4-byte floating point numeric
RANGE Get BIP10V
SLOPE Get 4-byte floating point numeric
VALUE Set/Get 0 to 65,535 counts
AOCAL
AIRES Get S24 (24-bit signed value)
LOCK Set
RES Get U16 (16-bit unsigned value)
UNLOCK Set
AOCAL{ch}
AIOFFSET Get
Double precision floating point numeric
(hex bytes). The channel is ignored.
AIRANGE Get BIP10V
AISLOPE Get
Double precision floating point numeric
(hex bytes). The channel is ignored.
AIVALUE Get Counts
OFFSET Set/Get Double precision floating point numeric
SLOPE Set/Get Double precision floating point numeric
VALUE Set/Get 0 to 65,535 counts
AOSCAN
1
EXTPACER Set/Get ENABLE, DISABLE
HIGHCHAN Set/Get 0 to 1
LOWCHAN Set/Get 0 to 1
RANGE Get BIP10V
RATE Set/Get 1 kHz to 500 kHz (1 channel)
SAMPLES Set/Get
0 to N
(0 = continuous scan; N = 32-bit)
STALL Set/Get ENABLE, DISABLE
START Set
STATUS Get IDLE, RUNNING, UNDERRUN
STOP Set
CTR{ch}
START
STOP
VALUE
Set 0
Get 0 – 4,294,967,295